Here’s a test composition using another patch I created for Curve titled Auto Octave Filter Sweep by AudioCookbook. On this patch I used two of the LFOs. The first one I setup to alternate between the octaves with a square wave, and the second I used with a sign wave to modulate the cutoff frequency on the filter configured with a 24dB low pass filter. On the second LFO I used the fixed rate that ranges from 0.020 hertz all the way up to 5.24 kilohertz. I mapped a MIDI controller to the LFO speed and adjusted it over the full range during the sequence. I also made adjustment to the cutoff frequency, resonance, and envelopes during the 5:20 minute recording.
Cableguys.de have recently released an excellent community-driven software synthesizer called Curve (downloadable demo available). The synth has three, aliasing-free oscillators, three five stage envelopes, two filters each with ten modes, and four LFOs that are either, beat, note, or frequency synced. One of the coolest things you can do is draw your waveforms in the editor. You can even randomize them for some interesting results. Here’s a sequence that I created and recorded without any processing using Curve. This is one of my first attempts at creating a patch in Curve and I shared it to the preset community (available within Curve’s interface) as Bouncy Arpeggiator by AudioCookbook. Stay tuned for a lot more from this powerful and great sounding software synth.
I just got a note from Dan Pugsley of Radium Audio. regarding their new resource Radium Audio Labs. The site will feature a broad variety of sound experiments and explorations. Dan writes,
“Radium Audio has recently started a blog demonstrating some of our explorative processes, and though it’s very much in the early stages of development we have some pretty interesting pieces uploaded already and I was wondering if any of it might be suitable for Audio Cookbook? We have two new explorative projects in the works at the moment, one of which is based on binaural recordings and the other will be revolving around the use of dry ice to create a variety of sounds.”
The projects posted so far include using a coil mic to record the electromagnetic fields from various electronic devices, like an iPhone and a printer/scanner, and my favorite at the moment, sounds captured from a contact microphone frozen in water ice as it melts.
I extracted this recording of the Posc from a performance of Words to Dead Lips at Intermedia Arts last November. I left the processing on it that I had used during the performance. At some point I’m going to acoustically record one of the “noise shields” that built for the dancers to use in the piece as a comparison. The “noise shields” have a distinctive sound tailored by the amplification, speaker, and the body of the instrument that is quite different for the direct sound below.
Here’s another result of experimenting with the Roland Juno-106. I created this sound by using the VCF as a pseudo oscillator. I cranked up the resonance to full, and put the cutoff at about half way, then turned off both the square and sawtooth DCOs. You might assume that with the oscillators off, including the noise and the the suboscillator, that the synth would make no sound, well it doesn’t really until you almost max out the resonance. Maxing out the keyboard slider changes the pitch of the notes on a roughly twelve tone scale, but it’s not well tempered, so this creates an eerie detuning between the notes. See the photo above for the exact settings. In the recording you’ll notice an abrupt key change happening a few times where I turned on the sawtooth oscillator. I also nudged the LFO on the VCF here and there to add to the spooky factor.
I’ve done a similar thing with the Pro One before, but it sounds really nice in six voice polyphony on the 106. My guess at what’s happening is that a sort of controlled resonant feedback on the instrument’s noise floor is creating the pitches. This is something that doesn’t really work with digital filters on modeling synths, as far as I know. I know that I haven’t been able to reproduce this behavior on the Korg MS2000. I don’t fully understand what’s happening, but that’s my theory. If anyone has better insight, please share a comment on the article.
