Drone Trick with Arturia KeyStep and Novation Circuit

Look, ma! No capo!

Lately I’ve been using a capo (yes the kind for guitar) to hold down a note on the KeyStep in order to drone a note on the Novation Circuit’s Synth 1 while playing notes on Synth 2. It’s awkward but works. Today while prepping for ISSTA.ie I stumbled on a way to drone a note on the Circuit with the KeyStep and no capo necessary! Here are the steps to drone Synth 1 and then play new notes/sequences/arps on Synth 2:

1. Make sure the KeyStep is setup in Keyboard Play mode by pressing Shift and Oct+.
2. Enable hold by pressing the Hold button.
3. Put the KeyStep in pause mode so that the pause/play button is flashing.
4. Hold Shift and press the low F to set the KeyStep to MIDI channel 1.
5. Play and hold the note(s) you’d like to drone (anything but the low Gb because you’ll need that key to switch channels)
6. Keep holding the note(s) and switch to MIDI channel 2 (Shift + the low Gb).
7. Un-pause play/pause and release the note(s)

Once you’ve lifted the note(s) you can re-pause or play arps or seqs on Synth 2 because essentially you have a stuck note on Synth 1 (just double tap stop to unstick the note). If you don’t want to hear Synth 2 when un-pausing, just make sure it’s down in the mix. This trick works while the Circuit is stopped or playing and will continue until double tapping stop on the KeyStep. It’s even possible to change the existing stuck note(s) by following the same steps. It’s easier than it reads, as you will see in the video below:

2 thoughts on “Drone Trick with Arturia KeyStep and Novation Circuit

  1. You can get drones on the Circuit by setting the gate to 16 steps and setting the note tie from the microsteps page to on, no?

Leave a Reply